![]() The individual cutters are then free to be removed one by one and the new ones slotted into place. Either way, twist the locking mechanism anti-clockwise to release and remove and put to one side. Depending on the make and model you will either have a combined locking mechanism that locks all of the cutters into the head together or each cutter will be individually locked into place. Once disconnected you are ready to remove the cutters. Press the release key on the front edge of the shaver head and it will flip up and open allowing you to pull the head off the shaver body completely. For some you simply disconnect and replace the whole shaver head - easy peasy! The other method, which involves replacing the individual cutters is a bit more tricky, especially on the first time around but once you get the knack it only takes a minute. You replace the blades on rotary shavers in one of two ways, depending on your shaver model. It’s a good idea to check the foil for dents and tears before each shave as exposed blades can cause painful nicks! Fitting new rotary heads to your rotary based shaver Having said that, if only the foil is damaged and the cutters are still sharp, you can get away with just replacing the foil. ![]() It’s good practice to replace both the foil and cutter at the same time for the optimum performance of your shaver. To fit the new cutting parts, carry out the same procedure in reverse. ![]() Hold the cutter block at its sides, rotate it 90 degrees counter-clockwise, so it is vertical to the shaver and then just pull it off. Removing the foil exposes the blades so take care not to touch them as they will still be sharp enough to cut your fingers. First remove the foil, either by pressing the release button (if your shaver has one), or simply by pulling the foil away from the body of the shaver. Some older models supply their foil and cutter as two independent parts which need to be changed in two steps. ![]() Simply locate the release button on each side of the shaver head and press firmly to release and separate the cartridge from the shaver. Replacing the cutting parts on a foil electric shaver is a piece of cake, especially when it comes to newer models where the foil and cutter are combined into a single cutting head cassette. This totally depends on your body hair and the brand of epilator you're using.Replacing your shaver's cutting heads? Fitting a new foil to your foil based shaver Some epilators can be even be used in the shower. It's a good idea to open the pores up first by having a hot shower or bath. Bikini lines and underarms can be more painful than legs because the skin is more sensitive here. This really depends on your pain threshold and the area you are epilating. So it's a great gadget to invest in for the summer months when you've got more skin on display. You can expect to go at least three weeks without stubbly legs or pits. Most skincare experts agree that it if used both regularly and correctly, the results can last up to four weeks, which is a hell of a lot longer compared to using a razor. Compared to shaving, which cuts hairs on the skin's surface, epilators remove the entire hair from the root, meaning it will take a while to grow back, leaving you more time without stubble. The devices tend to have tiny tweezers that rotate to constantly pluck the hairs from skin as you move it over your body.īecause it works in this unique way, it's able to pluck lots of hairs at once, even those small, fine hairs in hard to reach areas. Akin to waxing, epilators work by removing hair from the root.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |